Analog Output Units
Internal Circuits
Note
1. Connecting the Analog Output Unit
Connect the Analog Output Unit to the CPU Unit.
CPU Unit
2. Wiring Analog Outputs
Analog ground
■ Wiring for Analog Outputs
V OUT
Analog
I OUT
output
COM
unit
(1) Separate wiring from power lines (AC power supply lines, high-voltage
lines, etc.)
(2) When there is noise in the power supply line, install a noise filter on the
input section and the power supply.
(3) When external power is supplied (when range codes are set), or when the
power is interrupted, there may be a pulse status analog output of up to
1 ms. If this status is a problem, take the following measures.
• Turn ON the power to the CP1H CPU Unit, check the operation status,
and then turn ON the power at the load.
• Turn OFF the power to the load and then turn OFF the power to the
CP1H CPU Unit.
CPM1A-DA041
Analog Output Unit
OUT
CH
I OUT1
VOUT2
COM2
I OUT3
VOUT4 COM4
AG
VOUT1
COM1
I OUT2
VOUT3
COM3
I OUT4
NC
V OUT1
Analog output 1
I OUT1
COM1 (−)
to
to
V OUT4
Analog output 4
I OUT4
COM4 (− )
NC
+
Analog
Analog
device
with
output
voltage
−
unit
input
Section 7-3
+
V OUT
Analog
device
I OUT
with
−
current
COM
input
403