Omron CP1H CPU Operation Manual page 352

Pulse Outputs
Preparation
318
■ PLC Setup
Enable using built-in input IN0 as an interrupt input.
Note The interrupt input setting is read when the power supply is turned ON.
■ DM Area Settings
Speed Control Settings to Feed Wrapping Material to Initial Position
Acceleration rate: 1,000 Hz/4 ms
Target frequency: 10,000 Hz
Positioning Control Settings for Wrapping Material
Acceleration rate: 500 Hz/4 ms
Deceleration rate: 500 Hz/4 ms
Target frequency: 10,000 Hz
Number of output pulses: 5,000 pulses
Starting frequency: 0 Hz
Setting details
Setting details
Setting details
Section 5-3
Address Data
D0 #03E8
D1 #2710
D2 #0000
Address Data
D10 #01F4
D11 #01F4
D12 #2710
D13 #0000
D14 #1388
D15 #0000
D16 #0000
D17 #0000