PIAGGIO MP3 530 hpe Service Station Manual page 81

Machine Translated by Google
Electrical system
3) Turn the ignition key to OFF and connect the tester terminals between the negative (-) terminals.
on the battery and the black cable. Only then remove the black cable from the negative pole
Disconnect (-) at the battery.
4) With the ignition key still OFF, the ammeter must show a value of ÿ 0.5 mA.
Check charging voltage
WARNING
BEFORE CHECKING, MAKE SURE THE BATTERY IS IN GOOD CONDITION.
1) Place the vehicle on the main stand.
2) With the battery properly connected to the circuit, connect the tester terminals between the
Switch battery poles.
3) Start the engine, slowly increase the speed and measure the voltage at the same time.
Electrical information
Voltage between 14.0 and 15.0 V at 5000 rpm.
Control maximum delivered current
- With the engine switched off and the ignition lock set to "ON", switch the vehicle lights on and off
Wait until the battery voltage reaches 12V.
- Connect a clamp current meter to the 2 positive battery charge cables at the output of the controller
eat.
- Start the engine and bring it to high speed, at the same time take the reading on the clamp meter
read off.
Lamp list
In this section the equipment is included
Types of lamps provided for the vehicle
counted.
1
2
3
4
ELE ANL - 84
VOLTAGE REGULATOR/RECTIFIER
Technical information
Type
Tension
LAMP TABLE
Electrical information
Low beam lamp
High beam lamp
Lamp front parking light / daytime running light
Front turn signal lamp
Description/Value
Transistorized, non-adjustable three-phase
14 ÷ 15V at 5000 rpm with lights off
Description/Value
Typ: LED
Quantity: 1 RIGHT - 1 LEFT
Typ: LED
Quantity: 1 RIGHT - 1 LEFT
Typ: LED
Quantity: 1 RIGHT - 1 LEFT
Typ: LED
MP3 530 hpe