Table of Contents
Advertisement
Machine Translated by Google
MP3 530 hpe
Screw on the screws in the right part (2 short M8 screws).
Torque guide values (N*m)
Fasteners M8 drive cover 23 ÷ 26 Nm (17 ÷ 19 lb*ft)
Tighten the drive cover screws
(7 M6 screws).
Torque guide values (N*m)
Fasteners M6 drive cover 11 ÷ 13 Nm (8 ÷ 10 lb*ft)
Install the two washers as per the photo
ren; first the one with the smaller diameter,
then the one with the larger diameter.
Place the special tool in the designated areas
Insert slots, rotate the shaft if necessary,
to be able to fully introduce it.
Special tool
021022Y Stop guided pulley
Motor
AGAINST - 247
Advertisement
Table of Contents
