Table of Contents
Advertisement
Machine Translated by Google
MP3 530 hpe
- The nut in the same installation position as
attach beforehand (mother side contact Tel
disk).
- Assemble the special tool by
first attach the two retaining straps to the strap
disc attaches so that the notch is complete
rests.
- The 2 fastening screws can also be tightened by hand
screw the main tool.
Special tool
020474Y Key to block the on
drive pulley
- Fasten with a 27mm wrench
Drive pulley nut with the specified one
Tighten the specified torque.
- Remove the special tool.
Torque guide values (N*m)
Nut drive pulley 160 - 175
Installing the gearbox cover
- Put on the drive cover.
Motor
AGAINST - 143
Advertisement
Table of Contents
