Table of Contents
Advertisement
Machine Translated by Google
MP3 530 hpe
Installation of tappet cover
- Check the condition of the seal.
- The valve cover with the specified one
Secure torque.
Torque guide values (N*m)
Valve cover fixing screws 7 ÷ 9 Nm (5.2 ÷ 6.6
lb*ft)
Installation of intake manifold
- Attach the intake manifold to the engine.
- Insert the 3 fastening screws. One
The mounting screws have a fastening
clamp for the cooling line hose. The
Fastening screws with the specified
tighten to a certain torque.
Torque guide values (N*m)
Screws intake manifold 11 ÷ 13
Engine housing and crankshaft
- The outer and inner drive covers and the drive pulley complete, as in chapter
Remove the "automatic transmission" as described.
- The alternator cover with the hoses of the cooling system as described in the chapter «End of the alternator
Remove the lid as described.
- Install the flywheel magneto with starter as described in the "Alternator and starter system" chapter
dismantle the writing.
Motor
AGAINST - 201
Advertisement
Table of Contents
