Table of Contents
Advertisement
Machine Translated by Google
MP3 530 hpe
Parking brake
EXPANSION
- In preparation, remove the exhaust end part
ren.
- The two right-hand fastening screws
Remove fender.
- Loosen the brake control cable adjusting nut
sen, then the cable from the corresponding lever
remove.
- The two fastening screws of the mecha
Remove the niche brake caliper.
- Lift the rear fender slightly and
Remove the brake caliper from its seat on the retaining bracket
men.
- After removing the back of the shield, the cable
to switch on the protection device from the
Remove and separate your own seat.
- When reinstalling, as shown in the photo, special
different to the correct insertion of the cylindrical
Make sure the metal end fits into its seat.
Brake system
BRAKE - 255
Advertisement
Table of Contents
