Table of Contents
Advertisement
Machine Translated by Google
MP3 530 hpe
A= remote control
B= Master key
1. Checking the initial conditions:
1.1 Battery voltage over > 12V,
1.2 The master key must be available
1.3 All remote controls to be coded must be present (including those already available before
process coded),
1.4 The PADS diagnostic instrument must be connected to the vehicle's OBD connector
to do this, use the special tool.
Special tool
020922Y Diagnose-Instrument
021017Y Diagnostic cable EOBD E5
2. Start the duplication process before Up
call the self-diagnosis Keyless
PADS:
2.1 Ignition key to "OFF",
2.2 The remote control by pressing the first
and deactivate the second button.
2.3 Press the ignition lock and at the same time
Master key (mechanical key).
approach the keyless control unit. (*)
2.4 After the emergency indicators flash, the
Turn the ignition key to "ON" (**).
(*) The master key is with an integ
equipped with a transponder and must be on
the contact between the back of the shield and the inner part
be approximated at the top left, where the
Keyless control unit is located.
(**) From the moment the selector switch
is set to "ON", the process must be completed
Programming the remote controls internally
half of 120 seconds can be started (Be
write in step 3. Otherwise the
The process can be started from step 2.
Electrical system
ELE ANL - 117
Advertisement
Table of Contents
