Table of Contents
Advertisement
Machine Translated by Google
MP3 530 hpe
Torque guide values (N*m)
Alternator cover screws 11 ÷ 13 Nm (8 ÷ 10 lb*ft)
Alternator and starter system
- To make the alternator cover easier to remove
To be able to build, the three in the illustration must
The clamps shown in the diagram are removed and the socket
the supply line on the cylinder and the return line on
Pump cover must be removed.
ANNOTATION
THE CLAMPS NEED TO BE REPLACED.
THEY CAN BE OPENED WITH A SCREWDRIVER
OR CUT THROUGH FOR REMOVAL.
MAKE SURE THAT THE PLASTIC CONNECTIONS
ARE NOT DAMAGED.
The starter motor is sold complete.
Before replacing the starter motor,
the following must be checked:
1 - Battery
Measure the battery voltage in idle state
(rest for a few hours): Voltage
> 12.5 V.
Check the electrolyte density in each battery element
fen:
Baby = 30 ÷ 32
Specific gravity: 1.25 ÷ 1.26
YES point 2 NO point 3
2 - The correct connection of the negative terminals
(negative terminal of the battery and ground connection of the
starter motor) with each other and with the yard
check menu.
YES - point 4 NO point 5
3 - Charge or change the battery if necessary.
4 - Connect the diagnostic tester (see chapter «Injection»).
The induction clamp of an ammeter on the positive cable of the starter motor power supply
connect.
Remove fuse No. 12 with 10 A (see chapter "Fuses").
With the switch in "RUN" and the side stand raised, set it to "ON".
Select the «PARAMETER» function from the menu.
Motor
AGAINST - 165
Advertisement
Table of Contents
