Machine Translated by Google
Motor
ANNOTATION
DO NOT MIX THE INSTALLATION POSITION OF THE VALVES. INSTALL THE VALVE SPRINGS SO
THAT THE MARKING COLOR POINTS TOWARDS THE HALF-CONES (SPIRALS WITH LARGER
SPACING).
Check camshaft
- Check the running surfaces of the camshaft with a microphone
measure rometer.
-Measure the cam height with a gauge.
- If abnormal wear or other
Values than those in the "Technical data" section
specified, the No. must be determined
Camshaft needs to be replaced.
- The groove and the corresponding retaining plate
Check for wear (see illustration).
- Check that the cam for the automatic
Valve lifter and the end stop roller no Ver
show wear.
- The spring of the valve lifter for overstretching
check.
- In case of wear and tear, the appropriate construction must be carried out
parts need to be replaced.
- Check the rocker arm pins for scratches and wear.
Technical specifications
Standard diameter:
Ø 13 - 0,010 -0,018 mm
- The inside diameter on each rocker arm
measure.
Technical specifications
Standard diameter:
Ø 13 + 0,026 + 0,015 mm
- Check that the contact shoe with the cam and the joint part of the adjusting screws are not damaged
show signs of wear.
- If wear is detected, the corresponding component must be replaced.
AGAINST - 192
MP3 530 hpe