PIAGGIO MP3 530 hpe Service Station Manual page 203

Machine Translated by Google
Motor
- Install the circlip.
- Before installing a new bearing in the drive side
housing half, the bearing seat must be heated using
the specified special tool.
Special tool
020151Y hot air gun
- Grease the guide seat and install a new bearing
Attach the specified special tool.
- The new bearing in the housing half with the
Install the specified special tool.
ANNOTATION
IF A BEARING WITH A PLASTIC CAGE IS INSTALLED, IT
MUST BE INSERTED SO THAT THE VISIBLE SIDE WITH
THE BALLS IS TOWARDS THE INSIDE OF THE
HOUSING.
Special tool
020376Y Handle for adapter
020359Y Adapter 42 x 47 mm
020439Y Guide 17 mm
Checking the crankshaft components
- Check that the axial and diametric clearances of the connecting rod are within the values reported in the "Data" section
technicians".
- Check that the internal surfaces of the crankshaft shoulders do not have scratches. By means of a
gauge, check the overall width of the crankshaft shoulders.
ANNOTATION
WHEN MEASUREMENT, MAKE SURE THAT THE MEASUREMENT RESULTS ARE NOT FALSED BY THE
ROUNDED REDUCTION RADIUS WITH THE RUNNING SURFACES OF THE CRANKSHAFT.
Technical specifications
AGAINST - 206
MP3 530 hpe