Table of Contents
Advertisement
Machine Translated by Google
MP3 530 hpe
Technical specifications
Diameter of running surface of shaft guided
pulley:
D = Ø 15 - 0.01 -0.02 mm
E = Ø 20 - 0.01 -0.02 mm
F = Ø 25 - 0,01 -0,02 mm
Checking the rear gearbox cover
- Check that the mating surfaces are not scratched or warped.
- Check the bearing surfaces.
If damage is found, the rear gearbox cover must be replaced.
Installing the shaft bearing of the guided pulley
- Heat the housing with the heat gun.
Special tool
020151Y hot air gun
- Remove the bearing of the shaft of the guided pulley
using the specified special tool
Insert it into its seat until it stops.
ANNOTATION
THE BALLS MUST BE VISIBLE FROM THE REAR GEAR
(THIS REQUIREMENT APPLIES TO ALL BEARINGS WITH
PLASTIC CONTAINERS).
Special tool
020376Y Handle for adapter
020360Y Adapter 52 x 55 mm
020364Y Guide 25 mm
Motor
AGAINST - 151
Advertisement
Table of Contents
