Table of Contents
Advertisement
Machine Translated by Google
MP3 530 hpe
Once the oil has stopped flowing from the
drain hole, unscrew the cartridge oil filter and re
move it.
Make sure the O rings are in good condition
Pre-filter and drain plug ring.
Lubricate them and refit the mesh filter and the
oil drain plug locking it to the torque
prescribed.
Refit the new cartridge filter carefully
lubricate the O-Ring before assembly.
Fill in the engine oil.
Since a certain amount of oil still remains in the
circuit, filling must be done with
oil from cap «A». Then start the vehicle, leave
turn it on for a few minutes and turn it off: afterwards
about 5 minutes check the level and if necessary
top up without ever exceeding the MAX level.
Replacing the cartridge filter must be
carried out at every oil change. For top-ups and
to replace, use new oil of the recommended type
liato.
ANNOTATION
THE OIL MUST BE CHANGED WITH THE ENGINE WARM.
Suggested products
Motor oil 5W-40 synthetic-based lubricant for 4-
stroke engines.
SAE 5W-40; JASO MA, MA2; API SL; ACEA A3
control
This step must be carried out when the engine is cold
be carried out as follows:
- Place the vehicle on level ground
Set the main stand.
- Unscrew the filler cap with dipstick «A»
Use, dry with a clean cloth
zen and screw it back in completely.
maintenance
WAR - 55
Advertisement
Table of Contents
