Table of Contents
Advertisement
Machine Translated by Google
MP3 530 hpe
Crankshaft width
65,45 ÷ 65,6 mm
DANGER
THE CRANKSHAFT CAN BE REUSED IF THE WIDTH MATCHES STANDARD VALUES AND THE
SURFACES ARE NOT SCRATCHED.
Rasamento
- Check the overall dimension of the crankshaft-shim-
gear assembly.
Technical specifications
Standard size
XXX ÷ XXX mm
- Check that the scraper disk is not scratched.
ANNOTATION
IF REUSED, KEEP THE ORIGINAL INSTALLATION POSITION.
Special tool
020074Y Holding device for checking crankshaft alignment
- Is the axial play between the crankshaft and the engine housing larger than the normal values, but the crankshaft knows
If there are no abnormalities, the problem is certainly due to wear or incorrect processing on the engine
housing.
- Check, according to the axes and planes indicated in
figure, that the diameters of both flow rates of the
the crankshaft falls within the values reported in the
"Technical Data" section .
- The half-shafts are classified into two categories:
"Class 1" and "Class 2" and the diameters of the flow rates
are shown in the Car coupling table
ter - Crankshaft - Main bearing halves.
DANGER
If anomalies or values that do not comply with those specified are found, proceed with replacing the
complete crankshaft.
Check alignment of the crankshaft
- Install the crankshaft on the special bracket and check that the eccentricity values are in
are within the values specified in the "Technical data" section .
Special tool
020074Y Holding device for checking crankshaft alignment
Motor
AGAINST - 207
Advertisement
Table of Contents
