Table of Contents
Advertisement
Machine Translated by Google
MP3 530 hpe
- Install a new ball bearing using the specified
special tool.
Special tool
020376Y Handle for adapter
020477Y Adapter 37 mm
020363Y Guide 20 mm
- Insert the circlip.
Assembling the guided pulley
- Insert the new shaft seals.
- Insert the new O-rings.
ANNOTATION
THE TWO O-RINGS ARE DIFFERENT SIZES. THE LARGE O-RING IS PLACED ON THE
CIRCUMFERENCE OF THE WORKING END ON THE BASE OF THE BELT HALF-PULLEY.
- Place the belt half pulley onto the bushing
Zen. Be sure to make sure that the above
right sealing ring is not damaged.
- Check the pins and collar ring for wear
check and install.
Using a curved nozzle grease gun, grease the guided pulley assembly with approximately 10g
grease. The grease is inserted into the inside of the bushing through one of the holes until it
begins to emerge on the opposite side. This step is necessary to ensure that no grease gets behind the
O-rings.
Recommended products
Lubricating grease with molybdenum disulfide Lithium grease with the consistency of a paste, contains
molybdenum disulfide.
Grey-black grease
Motor
AGAINST - 135
Advertisement
Table of Contents
