Table of Contents
Advertisement
Machine Translated by Google
body
- Connect the cable connectors of the cabling and
Install panel "A" on the back of the shield.
- Tighten the two fixing screws and repeat the work for the
panel on the opposite side.
- Install both cushions on the back of the shield
and make sure the mounting pins are correct
are used properly.
- Install the handlebar covers.
- Install the shield front.
Front wheel housing
EXPANSION
- Remove the front of the shield.
- The two upper fastening screws of the
Remove the wheel housing on both sides.
- The lower fastening screw on both sides
remove ten.
WARS - 292
MP3 530 hpe
Advertisement
Table of Contents
