Table of Contents
Advertisement
Machine Translated by Google
MP3 530 hpe
Installation of alternator cover
- Install a new oil filter, the gasket
Lubricate by hand until it stops
screw and then with the provided
Tighten the specified torque.
Torque guide values (N*m)
Engine oil filter 12 ÷ 16
- The sleeve of the supply line on the cylinder and the
Reattach the return line to the pump cover
and fasten with new clamps.
ANNOTATION
THE CLAMPS MUST BE WITH THE APPROPRIATE
CLAMP PLIERS MUST BE INSTALLED
MAKE SURE THAT ON THE ONE HAND
HOSES ARE NOT PRESSED TOO STRONG, BUT
ARE FIXED SUFFICIENTLY.
- The pre-filter and the oil drain plug again
attach and with the prescribed rotation
tighten moment.
- Fill the specified engine oil into the engine.
Suggested products
Motor oil 5W-40 synthetic-based lubricant for 4-stroke
engines.
SAE 5W-40; JASO MA, MA2; API SL; ACEA A3
Torque guide values (N*m)
Oil drain plug engine oil 24 ÷ 30
- The seat of the intermediate gear with torque
ment limiter on the alternator cover
lubricate.
- The drive of the water pump on a Markie
Alignment and the alternator cover
as described in the alternator cover chapter
install.
Motor
AGAINST - 163
Advertisement
Table of Contents
