PIAGGIO MP3 530 hpe Service Station Manual page 209

Machine Translated by Google
Motor
Torque guide values (N*m)
Fastening screws gear to crankshaft 10 -12
- The crankshaft bearing on the housing half
Lubricate alternator side.
- Grease the compensating disk.
- The crankshaft and the balance disk in
Insert original position.
- Insert a bolt with an 8 mm diameter into the opening
Insert voltage on the countershaft.
- Place the crankshaft on the mandrel (carefully done).
hen) and then into the crankshaft bearing
insert.
- Before the crankshaft is fully inserted
the gears of the oil pump and that
Drive gear aligned with each other
the.
- Finish inserting and remove the bolt.
ANNOTATION
WHEN INSERTING THE CRANKSHAFT INTO THE HOUSING HALF, MAKE SURE THAT THE
THREADED PART OF THE CRANKSHAFT AND THE VALVE TIMING PINION THE CRANKSHAFT
BEARINGS NOT DAMAGED.
- Insert the partition wall to the oil pump room.
- The 2 flanged screws with the provided
Tighten the specified torque.
Torque guide values (N*m)
Screws for oil pump compartment partition wall 8 - 10
AGAINST - 212
MP3 530 hpe