Table of Contents
Advertisement
Machine Translated by Google
MP3 530 hpe
Level control
BRAKE FILL LEVEL CHECK
SYSTEM FRONT AND REAR
The brake fluid reservoirs for the front and
Rear brakes are on the handlebars. How
proceed as follows:
- The vehicle is aligned in the direction of travel
Place the handlebars on the main stand.
- Check the brake fluid level through the
corresponding sight glass. A slight drop in the
brake fluid level can occur
caused by wear on the brake pads.
FLUID CONTROL AT THE INTEG
RAIL BRAKE SYSTEM
- Place the vehicle on level ground
Set the main stand.
- Remove the control cover and check whether the
Level of brake fluid in the reservoir
written area can be read.
- A slight drop in brake fluid
tands can be caused by wear of the brake pads
be caused.
Refill
REFILLING THE FRONT BRAKE SYSTEM
AND BACK
Proceed as follows for both master brake cylinders:
- Loosen the two fastening screws and
remove the lid. To refill
finally prescribed brake fluid
to use. Never fill above the maximum level.
Under normal climatic conditions must
the brake fluid according to the information
from the maintenance program table
be changed.
WARNING
maintenance
WAR - 63
Advertisement
Table of Contents
