PIAGGIO MP3 530 hpe Service Station Manual page 161

Machine Translated by Google
Motor
- Install a new gasket on the engine housing
gen.
- Make sure the 3 centering pins are present
are.
- Turn the crankshaft until the drive
the countershaft to a mark on the gear
house is aligned (see illustration).
- The water pump shaft on the same mark
Align the connection on the housing.
ANNOTATION
THESE PROVISIONS ARE PARTICULARLY USEFUL
IF THIS WORK IS CARRIED OUT WITH THE WATER
PUMP COVER IN PLACE.
- Install the alternator cover, making sure that the stator and rotor are not in contact
jam.
WARNING
FAILURE TO FOLLOW THIS INSTRUCTION MAY RESULT IN THE BREAKAGE OF THE CERAMIC MAGNETS
LEAD.
- The alternator mounting screws
nenlid according to the position noted during removal
position, ensuring correct assembly
the cable routing of the oil pressure sensor and the
Pay attention to the holder of the sleeve.
1 medium screw 75 mm
9 medium length screws 40 mm
3 short screws 31 mm
AGAINST - 164
MP3 530 hpe