Table of Contents
Advertisement
Machine Translated by Google
MP3 530 hpe
Installation of cylinder head and valve control components
- Insert the chain guide shoe.
- The centering pins for the cylinder head and cylinder
insert.
- Install the cylinder head gasket.
The cylinder head gasket is made of steel and has a
Standard thickness.
ANNOTATION
THE PICTURE SHOWS THE INSTALLATION OF THE TWO CENTERING PINS BETWEEN THE CYLINDER
HEAD AND THE CYLINDER. THE INSTALLATION POSITION OF THE SEAL IS DETERMINED BY THE
TWO CENTERING PINS.
- The cylinder head must be checked before installing
whether the lubrication channels are really clean.
If necessary, use a jet of compressed air
blow.
- Mount the cylinder head.
- Lubricate the four stud screws and the 4 nuts
ren.
- Tighten the fixing nuts in a criss-cross sequence as
indicated in the figure to the prescribed torque.
Torque guide values (N*m)
Fastening nuts cylinder head - cylinder
13 Nm + 90° + 90°
***
First apply a pre-torque of 13 Nm in a crisscross sequence.
Motor
AGAINST - 193
Advertisement
Table of Contents
