PIAGGIO MP3 530 hpe Service Station Manual page 196

Machine Translated by Google
MP3 530 hpe
- If different values are measured, this must be done
the valve clearance can be adjusted. In addition, the con
Loosen the nut and tighten the adjusting screw with a
Adjust screwdriver (see illustration).
Installing the chain and adjusting the valve timing
The ignition timing is advanced (pre-ignition) based on the ignition electronics
averaged parameters. For this reason, reference values based on engine speed cannot be used
be specified.
The pre-ignition values can be determined at any time using the diagnostic test device.
A stroboscope lamp can be used to check whether the preset specified by the injection system
The ignition timing position corresponds to the actual ignition timing on the engine.
Special tool
020922Y Diagnose-Instrument
020330Y Strobe lamp to check the ignition setting
Proceed as follows:
- As described in the "Automatic transmission" chapter
remove the drive cover.
- The lock on the inspection opening for the TDC mark between the alternator and the housing
Remove the water cover. See chapter "Alternator cover".
REQUIRED PLAY:
Technical information
inlet
outlet
Description/Value
0.15 mm (when engine is cold)
0.15 mm (when engine is cold)
Motor
AGAINST - 199