See Also
Copyright © 2019, Juniper Networks, Inc.
Figure 123: Removing a PIC
MX240 PIC Description on page 104
Troubleshooting the MX240 PICs on page 356
Preventing Electrostatic Discharge Damage to an MX240 Router on page 380
MX240 PIC Serial Number Label on page 369
Installing an MX240 PIC
To install a PIC (see
Figure 124 on page
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
If the PIC uses fiber-optic cable, verify that a rubber safety cap is over each transceiver
2.
on the faceplate. Install a cap if necessary.
Align the notches in the connector at the rear of the PIC with the notches in the PIC
3.
slot in the FPC and then slide the PIC in until it lodges firmly in the FPC.
CAUTION:
Slide the PIC straight into the slot to avoid damaging the
components on the bottom of the PIC.
Chapter 4: Maintaining, Installing and Replacing Components
293):
291