Installing An Mx240 Pic; Figure 99: Installing A Dual-Wide Mic - Juniper MX240 Hardware Manual

Related
Documentation

Installing an MX240 PIC

Copyright © 2017, Juniper Networks, Inc.
Issue the following CLI command:
user@host> request chassis mic fpc-slot mpc-slot mic-slot mic-slot online
The normal functioning status LED confirms that the MIC is online. You can also verify
correct MIC functioning by issuing the
in "Maintaining MX240 MICs" on page

Figure 99: Installing a Dual-Wide MIC

MPC
Dual-wide MIC
MX240 Modular Interface Card (MIC) Description on page 70
Troubleshooting the MX240 MICs on page 408
Removing an MX240 MIC on page 307
MX240 MIC Serial Number Label on page 424
To install a PIC (see Figure 100 on page
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
If the PIC uses fiber-optic cable, verify that a rubber safety cap is over each transceiver
2.
on the faceplate. Install a cap if necessary.
Align the notches in the connector at the rear of the PIC with the notches in the PIC
3.
slot in the FPC and then slide the PIC in until it lodges firmly in the FPC.
CAUTION: Slide the PIC straight into the slot to avoid damaging the
components on the bottom of the PIC.
For an FPC3 PIC, turn the ejector handle at the top of the PIC faceplate clockwise,
4.
then tighten the captive screw at the bottom of the faceplate to secure the PIC in the
FPC.
If the PIC uses fiber-optic cable, remove the rubber safety cap from each transceiver
5.
and the end of each cable.
Chapter 21: Installing Components
show chassis fpc pic-status
393.
249):
command described
247