See Also
Installing a T4000 PIC
Copyright © 2018, Juniper Networks, Inc.
Figure 120: Removing a PIC
T4000 PIC Description on page 62
Maintaining T4000 PICs on page 338
Troubleshooting the T4000 PICs on page 363
Prevention of Electrostatic Discharge Damage on page 423
To install a PIC (see
Figure 121 on page
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
If the PIC uses fiber-optic cable, verify that there is a rubber safety cap over each
2.
transceiver on the faceplate. Install a cap if necessary.
Chapter 30: Replacing Line Card Components
305).
303