Installing An M10I Pic - Juniper M10i Hardware Manual

Installing an M10i PIC

Copyright © 2010, Juniper Networks, Inc.
All manuals and user guides at all-guides.com
To install a PIC (see Figure 43 on page 114):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
If the PIC uses fiber-optic cable, verify that there is a rubber safety cap over each
2.
transceiver on the faceplate. Install a cap if necessary.
Prepare the PIC for insertion into the chassis:
3.
For a regular PIC, hold the PIC in one hand and with your other hand pull the end of
the ejector lever away from the PIC faceplate. Hold the lever out while you insert
the PIC.
For a quad-wide PIC, verify that the end of each ejector lever is pulled away from
the PIC faceplate, toward the ends of the PIC.
Align the rear of the PIC with the guides located at the bottom corners of the PIC slot.
4.
Slide the PIC into the slot:
5.
For a regular PIC, slide the PIC into the slot until about 0.5 in. (1 cm) of the PIC
remains outside the slot and you feel some resistance. Release the ejector lever
and gently push the PIC faceplate until you hear a click as the PIC contacts the
midplane. The ejector lever engages and closes automatically.
For a quad-wide PIC, slide the PIC into the slot until it contacts the midplane. Push
the ejector levers inward toward the PIC faceplate to seat the PIC securely in the
chassis.
CAUTION: Slide the PIC straight into the slot to avoid damaging the
components on the PIC.
If the PIC uses fiber-optic cable, remove the rubber safety cap from each transceiver
6.
and the end of each cable.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
CAUTION: Do not leave a fiber-optic transceiver uncovered except when
inserting or removing cable. The safety cap keeps the port clean and
prevents accidental exposure to laser light.
Insert the appropriate cables into the cable connectors on the PIC.
7.
Chapter 15: Replacing M10i Hardware Components
113