T4000 Lcc-Cb; T4000 Lcc-Cb Control Board Leds; Figure 19: Lcc-Cb; T4000 Craft Interface Leds - Juniper T4000 Hardware Manual

Related
Documentation
Copyright © 2013, Juniper Networks, Inc.

T4000 LCC-CB

Each LCC-CB consists of the following components:
100-MB Ethernet switch for intermodule communication.
PCI bus to the Routing Engines.
Switch processor mezzanine board (SPMB).

Figure 19: LCC-CB

The following components are located on the LCC-CB faceplate:
Two configuration switches:
The M/S configuration switch must be set to
The configuration switch must be set to
CHASSIS ID
Three LEDs labeled
MASTER
The online/offline button.
Six RJ-45 ports labeled
SFC0
LEDs for each port labeled
One JCS port, which is not currently supported. The
currently supported.
T4000 Control Board Description on page 36
T4000 Craft Interface LEDs on page 25
T4000 LCC-CB Control Board LEDs on page 37

T4000 LCC-CB Control Board LEDs

Status LEDs and port LEDs are located on the faceplate of the LCC-CB (see
Figure 20 on page 38).
Chapter 3: T4000 Hardware Components Overview
S .
, , and , which indicate the control board status.
FAIL OK
through , which is currently not supported. The two
SFC5
and are also not currently supported.
LINK ACT
LINK
.
0
LED for this port is also not
37