Replacing A T640 Standard Control Board Or T-Cb; Figure 148: Installing An Lcc-Cb - Juniper T640 Hardware Manual

Replacing a T640 Standard Control Board or T-CB

Copyright © 2017, Juniper Networks, Inc.

Figure 148: Installing an LCC-CB

The router can have up to two control boards. You can use this procedure for either
standard control boards or T-CBs. They are located in the upper rear of the chassis in
the slots marked and
CB0
To replace a standard control board or T-CB, perform the following procedures:
Removing a T640 Standard Control Board or T-CB on page 314
1.
2. Installing a T640 Standard Control Board or T-CB on page 315
Chapter 27: Replacing Host Subsystem Components
. Each weighs approximately 5 lb (2.3 kg).
CB1
313