08/MASK, FENDER
Installing the front trim
12.4
Removing the rear fender
12.5
–
Check parts for damage and wear. Replace damaged or worn parts.
–
Connect the plug-in connectors of the head light and the emergency OFF switch
with the rip cord and position the front trim.
–
Mount all screws.
–
Fully tighten screws
Specification
Screw on fuel tank
–
Fully tighten screws
Specification
Remaining screws, chassis
–
Install the front cover. (
100076-10
–
Remove the seat (
–
Remove screws
200149-10
–
Raise the rear of the air filter box lid
press on the carburetor connection boot to kink it at that location. This prevents the
carburetor connection boot from disconnecting from the carburetor.
–
Raise the fender
200148-10
.
M6
.
M6
P. 56)
P. 52)
. Remove the collar sleeves.
. At the same time, use your other hand to
at the rear and remove it.
57
6 Nm (4.4 lbf ft)
10 Nm (7.4 lbf ft)