Table of Contents
Advertisement
38/LUBRICATION SYSTEM
Removing the oil filter
25.3
Warning
Danger of scalding Engine oil and gear oil get very hot when the vehicle is driven.
–
Wear suitable protective clothing and gloves. If you scald yourself, hold the affected area under cold water immediately.
Warning
Environmental hazard Problem materials cause environmental damage.
–
Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc. according to regulations.
–
Check parts for damage and wear. Replace damaged or worn parts.
–
Thoroughly clean parts and sealing area.
–
Oil the O-rings
insert them until the O-ring is seated in the housing
–
Fit the plug screw
Specification
Locking screw, oil sieve, long
600144-10
–
Insert the oil screen
Specification
Locking screw, oil sieve,
short
600140-10
–
Fit oil drain plug
Specification
Oil drain plug with magnet
–
Install the engine guard. (
600134-11
–
Place a suitable container under the engine.
–
Disconnect the ground cable
–
Remove screws
600137-10
, mount them on the oil screen
with seal ring and tighten it.
M20x1,5
with the O-rings
into the plug screw
M16x1,5
with seal ring and tighten it.
M12x1,5
P. 18)
from the engine.
and
. Take off the oil filter cover with the O-ring.
and using a long hexagon key
with the oil screen.
15 Nm
(11.1 lbf ft)
and tighten.
10 Nm
lubricated with
(7.4 lbf ft)
engine oil
20 Nm
(14.8 lbf ft)
167
Advertisement
Table of Contents
