Table of Contents
Advertisement
31/CARBURETOR
31/CARBURETOR
21
Choke
21.1
Hot start button
21.2
Removing the carburetor
21.3
The choke
is fitted on the left side of the carburetor.
Activating the choke function frees an opening through which the engine can draw
extra fuel. This gives a richer fuel-air mixture, which is needed for a cold start.
Info
If the engine is warm, the choke function must be deactivated.
Possible states
Choke function activated – The choke lever is pulled out to the stop.
•
100014-10
Choke function deactivated – The choke lever is pushed in to the stop.
•
The hot start button (red)
Activating the hot start function frees an opening in the carburetor through which the
engine can draw extra air. This gives a leaner fuel-air mixture, which is needed for a
hot start.
Info
If the engine is cold, the hot start function must be deactivated.
Possible states
100015-10
Hot start function activated – The hot start button is pulled out to the stop.
•
Hot start function deactivated – The hot start button is pushed in as far as possi-
•
ble.
–
Remove the fuel tank. (
–
Remove the air filter box lid with the carburetor connection boot. (
–
Unplug the connector
600158-10
–
Remove screw
600442-10
–
Pull engine breather hose
600159-10
is fitted on the left side of the carburetor.
P. 53)
of the TPS throttle valve sensor.
. Take off the holder for the carburetor vent hoses.
off of the carburetor.
145
P. 51)
Advertisement
Table of Contents
