31/CARBURETOR
Checking the hot start slide
21.7
Checking the choke slide
21.8
Checking the jet needle
21.9
–
Check/adjust the throttle slide opening. (
Info
Adjusting the play of the accelerator pump changes the time at which injec-
tion starts and does not influence the injection rate or the intensity of the
accelerator pump.
–
Check piston rod overhang
Specification
Piston rod overhang
700065-10
»
If piston rod overhang
–
Correct the piston rod overhang by turning adjusting screw
–
Carburetor - adjust the idle speed. (
–
Check the hot start slide for smooth operation.
»
If the hot start slide cannot be moved easily or is soiled:
–
Clean the hot start slide.
Carburetor cleaner (
–
The piston of the hot start slide should not be damaged.
»
If the piston of the hot start slide is damaged or worn:
–
Change the hot start slide.
–
Check the rubber sleeve and lock.
600400-01
»
If the rubber sleeve is damaged or brittle, or if the lock does not function:
–
Change the hot start slide.
–
Check the choke slide for smooth operation.
»
If the choke slide cannot be moved easily or is soiled:
–
Clean the choke slide.
Carburetor cleaner (
–
The piston of the choke slide should not be damaged.
»
If the piston of the choke slide is damaged or worn:
–
Change the choke slide.
–
Check the rubber sleeve and lock.
600399-01
»
If the rubber sleeve is damaged or brittle, or if the lock does not function:
–
Change the choke slide.
–
Check the jet needle for bending and wear of the coating.
»
If the jet needle is bent or the coating is damaged or worn:
–
Change the jet needle.
–
Check that the needle clip is tight.
»
If the needle clip is not tight:
–
Change the needle clip or the jet needle.
700052-10
P. 153)
.
0.9... 1.0 mm (0.035... 0.039 in)
does not equal the specified value:
P. 157)
P. 205)
P. 205)
150
.