04/SHOCK ABSORBER, SWINGARM
Installing the rear shock absorber
8.20
Rear shock absorber - removing the spring
8.21
Rear shock absorber - installing the spring
8.22
–
Check parts for damage and wear. Replace damaged or worn parts.
–
Position the shock absorber in the vehicle with the reservoir on the right. Mount
and tighten the top screw
Specification
Screw, rear top shock absorber
–
Position the shock absorber in the swingarm. Mount and tighten the bottom screw.
Specification
Screw, rear bottom shock absorber
–
Remove the tension belt.
–
Install the rear fender. (
–
Remove the vehicle from the work stand. (
100079-10
–
Remove the rear shock absorber. (
–
Measure and note down the spring length in the preloaded state.
–
Loosen lock nut
Hook wrench (83019002000)
–
Turn the adjusting ring until the spring is no longer under tension.
200232-10
–
Remove spring retainer
–
Remove the spring with the washer.
200233-10
–
Position the washer under the adjusting ring.
–
Position the spring.
–
Mount spring retainer
200233-11
.
M12
M12
P. 58)
P. 36)
. Hold adjusting ring
while doing so.
.
.
60 Nm
(44.3 lbf ft)
70 Nm
(51.6 lbf ft)
P. 14)
37