30/ENGINE - WORK ON INDIVIDUAL PARTS
Checking electric starter operation
19.40
0 0 5
5
0 0 A
A
–
Check the toothing of starter motor
»
If there is damage or wear:
–
Change the starter motor.
–
Clamp the negative cable of a 12 volt supply to the starter motor housing. Connect the positive cable of the voltage supply briefly
to the connection of the starter motor.
»
If the starter motor does not turn when you close the circuit:
–
Change the starter motor.
–
Change O-ring
of the electric starter motor
–
Check the toothing and seating of starter idler gear
»
If there is damage or wear:
–
Change the starter idler gear.
–
Check the toothing or seating of torque limiter
»
If there is damage or wear:
–
Change the torque limiter with the bearing bolt.
–
Check the toothing of primary gear
»
If there is damage or wear:
–
Change the primary gear.
–
Check free-wheel
when removed for damage and wear.
»
If there is damage or wear:
–
Change the free-wheel.
–
Check free-wheel-gear
»
If there is damage or wear:
–
Change the free-wheel-gear and/or the bearing.
6
0 0 6
7
0 0 7
for damage and wear.
.
for damage and wear.
and the bearing bolt for damage and wear.
and contact surface
and the bearing when removed for damage and wear.
2
0 0 2
3
0 0 3
4
0 0 4
for damage and wear.
126
1
0 0 1
600323-01