Table of Contents
Advertisement
WORK
Installing the rear fender
3.5
Recharging the battery
3.6
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open fire. Charge only in well-ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
Warning
Environmental hazard Components and battery acid are a danger to the environment.
–
Do not dispose of batteries in normal household waste. Take defective or used batteries to a battery recycling operator.
Warning
Environmental hazard Problem materials cause environmental damage.
–
Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc. according to regulations.
Info
Even if there is no load on the battery, it loses power every day.
The charge state and the type of charge are very important for the service life of the battery.
Fast recharging with a high charge current shortens the battery's service life.
If the charge current, the charge voltage and the charge time are exceeded, electrolyte escapes through the breathing holes.
The battery capacity is then reduced.
If the battery is discharged from starting, it must be recharged immediately.
If it stands for a long time in a discharged state, the battery becomes over-discharged and sulfated, and then it is destroyed.
The battery is maintenance-free, i.e., the acid level does not have to be checked.
–
Raise the rear of air filter box lid
on the carburetor connection boot to kink it at that location. This prevents the car-
buretor connection boot from disconnecting from the carburetor.
–
Position front fender
–
Fix the air filter box lid in the fender.
Info
If the air filter box lid is not correctly mounted, dust and dirt can penetrate
into the engine and cause damage.
300255-11
–
Mount and tighten screws
Guideline
Remaining screws, chassis
–
Mount the seat. (
300254-11
. At the same time, use your other hand to press
.
.
M6
p. 5)
6
10 Nm (7.4 lbf ft)
Hide quick links:
Advertisement
Table of Contents
