10/REAR WHEEL
–
Position O-ring
–
Carefully insert sealing area
the rear wheel eccentric by lightly turning and tilting the rear axle.
Info
Do not damage the sealing lip of the shaft seal ring.
600425-10
–
Lightly grease the thread of the clamping nut.
Long-life grease (
–
Ensure that the rear axle and the brake disc holder have been correctly installed.
–
Turn clamping nut
Info
LH thread!
600426-10
–
Position lock rings
600427-10
–
Tighten the clamping nut in the direction of the arrow using the special tool.
Specification
Clamping nut, rear axle
Open-end wrench accessory 46mm (83019010461) (
600428-10
–
Tighten screw
Specification
Screw, clamping nut, rear axle
–
Position the brake caliper. Mount and tighten screws
Specification
Screw, rear brake caliper
–
Clean the brake disc and brake disc holder.
–
Operate the foot brake lever repeatedly until the brake linings lie on the brake disc
and there is a pressure point.
–
Fill the rear wheel eccentric with grease via grease nipple
600429-10
Long-life grease (
. Attach brake disc holder
on the brake disc carrier into the shaft seal ring of
P. 203)
all the way onto the brake disc holder.
.
2"-10UNS-
2B-LH
.
M6
M6
P. 203)
with the thread facing outward.
25 Nm
Only applies when
(18.4 lbf ft)
using:
Open-end wrench
accessory 46mm
(83019010461)
(
P. 210)
P. 210)
10 Nm (7.4 lbf ft)
.
Loctite
243™
10 Nm
®
(7.4 lbf ft)
.
66