04/SHOCK ABSORBER, SWINGARM
Rear shock absorber - assembling the piston rod
8.26
–
Remove seal ring holder
200251-10
–
Remove the locking cap and bump rubber.
200252-10
–
Clamp the piston rod with the heim joint in a vise.
–
Mount the bump rubber and locking cap.
200252-10
–
Position special tool
Mounting sleeve (83019050012) (
–
Grease the seal ring and slide seal ring holder
Lubricant (T625) (
–
Remove the special tool.
200257-10
–
Mount the plates.
200250-10
–
Mount supporting plate
Info
The compression damping shim set must be mounted with the smaller disks
facing downward.
200249-11
.
on the piston rod.
P. 214)
onto the piston rod.
P. 205)
and the lower compression damping shim set
44
.