11/WIRING HARNESS, BATTERY
15
11/WIRING HARNESS, BATTERY
Ignition curve plug connection
15.1
Changing ignition curve
15.2
–
Remove the front trim. (
Changing the ignition curve from Performance to Soft.
–
Connect the plug-in connector
Soft – The plug-in connector is connected for better driveability. (
Change the ignition curve from Performance to Soft.
–
Disconnect the plug-in connector
Performance – The plug-in connector is disconnected for better performance. (
–
Install the front trim. (
Removing the battery
15.3
Warning
Risk of injury Battery acid and battery gases cause serious cauterization.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open fire. Charge only in well ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a doctor.
Installing the battery
15.4
The plug-in connector
Possible states
Soft – The plug-in connector is connected for better driveability.
•
Performance – The plug-in connector is disconnected for better performance.
•
100105-10
P. 56)
. (Figure 100105-10
. (Figure 100105-10
P. 57)
–
Switch off all power-consuming components and switch off the engine.
–
Remove the rear fender. (
–
Disconnect the negative (minus) cable
–
Pull back the plus pole cover and disconnect the positive (plus) cable
tery.
–
Loosen the rubber band
–
Remove the battery.
200150-10
–
Check parts for damage and wear. Replace damaged or worn parts.
–
Place the battery in the battery holder.
4Ah battery (YTX5L-BS) (
–
Reconnect the rubber band
–
Attach the plus cable and replace the plus pole cover
–
Connect the negative (minus) cable
–
Install the rear fender. (
200150-11
is located under the trim at the front on the frame tube.
P. 69)
P. 69)
P. 69)
P. 69)
P. 57)
of the battery.
.
P. 190)
.
of the battery.
P. 58)
69
of the bat-
.