11/WIRING HARNESS, BATTERY
Changing the main fuse
15.6
Changing the fuses of individual power-consuming components
15.7
–
Switch off all power-consuming components and switch off the engine.
–
Main fuse
–
Remove protection covers
–
Remove the faulty main fuse.
Info
You can recognize a blown fuse by its broken filament
Warning
Fire hazard The electrical system can be overloaded by the use of incorrect
fuses.
–
Use only fuses with the prescribed amperage. Never by-pass or repair
fuses.
–
Insert the new fuse.
Fuse (58011109120)
Tip
Replacement fuse
sure it is available when needed.
100091-10
–
Replace the protection covers.
–
Remove the front cover. (
–
Switch off all power-consuming components and switch off the engine.
–
Open cover
Info
The designation of the fuses is located on the inside cover of the fuse
box
–
Remove the faulty fuse.
Specification
Fuse 1 - 10A - Ignition, CDI controller, indicator lamps ON, N, R
Fuse 2 - 15A - High beam, low beam, parking light, tail light, brake light, high
beam indicator lamp
Fuse 3 - 10A - Radiator fan
Fuse 4 - 10A - For auxiliary devices (permanent positive)
Fuse 5 - 10A - For auxiliary devices (positive terminal switched on with ignition
switch)
Fuse res. - 10A/15A - Replacement fuses
Info
You can recognize a blown fuse by its broken filament
100090-10
is located in starter relay
.
should always be present in the starter relay to make
P. 56)
of fuse box
.
.
in front of the battery.
.
.
71