30/ENGINE - WORK ON INDIVIDUAL PARTS
Removing the oil pressure regulator valve
19.2
Checking the spring length of the oil pressure regulator valve
19.3
Installing the oil pressure regulator valve
19.4
–
Blow though all oil holes with compressed air and check that they are clear.
600249-01
–
Remove plug
–
Remove pressure spring
600250-10
–
Remove the oil pressure regulator valve. (
–
Measure the spring length of the oil pressure regulator valve.
Bypass valve - minimum length of pres-
sure spring
»
If the measured value does not equal the specified value:
–
Change the spring.
–
Install the oil pressure regulator valve. (
200155-10
–
Check parts for damage and wear. Replace damaged or worn parts.
–
Insert piston valve
–
Mount plug
Specification
Plug, oil pressure regulator valve
600250-11
with seal rings
.
and piston valve
with pressure spring
with seal rings
and tighten.
.
P. 101)
23.5 mm (0.925 in)
P. 101)
.
M12x1.5
20 Nm
(14.8 lbf ft)
101