Table of Contents
Advertisement
10/REAR WHEEL
Installing the rear axle
14.9
Warning
Danger of accidents Reduced braking due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
–
Take brake disc
–
Remove the O-ring.
600412-10
–
Push the rear axle slightly to the left. Using a plastic hammer, lightly strike against
the chain sprocket carrier
rings. Remove lock rings
–
Pull the rear axle out of the swingarm in the direction of the arrow.
Info
Hold the rear sprocket carrier.
–
Remove rear sprocket carrier
600414-10
–
Slide on the rear axle from the left to the right all the way.
Info
The machined surfaces
600422-10
–
Position O-ring
–
Carefully insert sealing area
of the rear wheel eccentric by lightly turning and tilting the rear axle.
Info
Do not damage the sealing lip of the shaft seal ring.
600423-10
–
Position lock ring
the way in in the direction of the arrow.
–
Check that the lock rings are seated properly.
600424-10
off the rear axle with the holder.
to release the chain sprocket carrier from the lock
.
with the O-ring.
must be to the right of bearing seat
. Attach chain sprocket carrier
on the chain sprocket carrier into the shaft seal ring
with the high collar facing to the left. Slide the main shaft all
.
with the nuts facing outward.
65
Advertisement
Table of Contents
