04/SHOCK ABSORBER, SWINGARM
Front shock absorber - installing the spring
8.8
A
0 0 A
Alternative 1
–
Measure the overall spring length when not under tension.
Info
The spring preload
pack when it is unloaded and when it is installed.
–
Insert the locking clip into the corresponding groove.
Specification
Clip position, spring preload
Standard
Corresponds to a spring preload
of
Alternative 2
–
Position the locking clip in the position determined upon disassembly.
400347-10
–
Position the spring retainer with the groove facing the locking clip.
–
Position the washer.
–
Position threaded bush
200279-11
–
Mount protecting sleeve
200278-11
–
Position spring
–
Pull the spring down and mount spring retainer
–
Adjust the cross over of the front shock absorbers. (
–
Install the front shock absorber. (
200277-11
is the difference in length between the spring
with the spring.
.
.
P. 22)
7 th position from top
5 mm (0.2 in)
.
P. 20)
23