Table of Contents
Advertisement
10/REAR WHEEL
2
0 0 2
3
0 0 3
0 0 1
1
Removing the rear axle
14.8
Setting a wide toe width:
–
Mount the spacing sleeve
–
Mount the conical ring
–
Mount the wheel hub
–
Mount the washer and the new self-locking nut.
100104-10
–
Remove the vehicle from the work stand. (
–
Tighten nuts
Specification
Nut, rear wheel hub
–
Shift gear to neutral.
100102-10
–
Engage 1st gear.
–
Loosen nuts
–
Jack up the vehicle. (
–
Remove nuts
100102-12
–
Remove chain joint
600409-10
–
Loosen screw
–
Turn clamping nut
freely accessible. Remove the lock rings.
Open-end wrench accessory 46mm (83019010461) (
–
Turn clamping nut
600410-10
–
Remove screws
–
Push back the brake linings by tilting brake caliper
brake disc. Carefully pull the brake caliper off of the brake disc and let it hang to
one side.
Info
Do not operate the foot brake when the brake caliper has been removed.
600411-10
with the cone facing inward.
with the cone facing outward.
.
on both sides.
of the wheel hubs on both sides.
P. 14)
on both sides and take all parts off of the rear axle.
. Remove the chain from the rear sprocket.
.
counterclockwise using the special tool until lock rings
clockwise using the special tool and remove.
.
P. 14)
M18x1,5
130 Nm
(95.9 lbf ft)
P. 210)
slightly to one side on the
64
are
Advertisement
Table of Contents
