Table of Contents
Advertisement
10/REAR WHEEL
–
Take out shaft seal rings
600417-10
–
Remove old grease and clean the rear wheel eccentric.
–
Heat the rear wheel eccentric.
Specification
100 °C (212 °F)
–
Remove outer bearing races
–
Mount the new outer bearing races using the special tool.
Press mandrel (83019012000) (
600418-10
–
After the rear wheel eccentric has cooled, check that the bearing races are firmly
seated.
–
Insert the inner bearing race in rear wheel eccentric
–
Mount shaft seal ring
tool.
Press mandrel (83019012000) (
–
Insert the inner bearing race in rear wheel eccentric
–
Mount shaft seal ring
cial tool.
Press mandrel (83019012000) (
Info
Do not swap the shaft seal rings, as otherwise grease may get onto the brake
disc from the rear wheel eccentric.
–
Lightly grease the sealing lips of the shaft seal rings.
Long-life grease (
600420-10
–
Insert the rear wheel eccentric into the swingarm and align it with the marking
made when it was dismantled.
–
Tighten screws
Specification
Screw, rear wheel eccentric element
Info
The rear wheel eccentric element should always be positioned such that the
600416-11
grease nipple
ground clearance.
–
Position brake caliper support
–
Mount lock ring
–
Install the rear axle. (
600415-11
on both sides and remove inner bearing races
on both sides.
P. 211)
with the blue marking on the left side
P. 211)
with the green marking on the right side
P. 211)
P. 203)
.
M8
is visible. This ensures that the vehicle has the greatest
.
.
P. 65)
.
on the left side
.
. Use the special
on the right side
.
. Use the spe-
20 Nm
(14.8 lbf ft)
68
Advertisement
Table of Contents
