Table of Contents
Advertisement
61/ATV FRONT SECTION
Checking/adjusting camber
27.3
Info
The left and right camber should have the same settings.
The operations are the same on the left and right.
–
Jack up the vehicle. (
–
Loosen nuts
600128-10
–
Remove screws
–
Check parts for damage and wear. Replace damaged or worn parts.
600126-10
–
Insert the tool
Camber gauge (83019014000) (
–
Check the camber on both heim joints.
»
If the marking
–
Turn the tool
line with the top edge of the A-arm.
–
Remove the tool
600127-10
–
Position the A-arm with the bushings
Specification
Screw, A-arm top
600126-10
–
Align the heim joint at right angles to the screws
Specification
Nut, A-arm top
Info
All four heim joints must be checked and adjusted if necessary.
–
Remove the vehicle from the work stand. (
600128-10
P. 14)
.
with bushings
.
in the heim joint and clip onto the A-arm.
P. 211)
is not aligned with the top edge of the A-arm:
with the heim joint in steps of 180° until the marking is in
.
. Mount and tighten screws
.
M10x52
45 Nm
(33.2 lbf ft)
and tighten the nut
M12x1,25
30 Nm
(22.1 lbf ft)
P. 14)
174
.
Advertisement
Table of Contents
