30/ASSEMBLING THE ENGINE
Installing the starter motor
20.36
Installing the oil drain plug
20.37
Installing the oil screen
20.38
Mounting the oil filter
20.39
–
Grease the O-ring. Mount starter motor
Long-life grease (
–
Mount and tighten screw
Specification
Screw, starter engine
600388-10
–
Mount oil drain plug
Specification
Oil drain plug with magnet
600393-10
–
Oil the O-rings, mount them on oil screen
wrench insert them carefully until the O-ring is seated in the housing
screen.
600391-10
–
Mount plug
Specification
Locking screw, oil sieve, long
–
Insert oil screen
Specification
Locking screw, oil sieve,
short
600392-10
–
Tilt the engine sideways and fill the oil filter housing about ⅓ full with engine oil.
–
Fill the oil filter
600389-10
P. 205)
.
with seal ring and tighten it.
with the seal ring and tighten.
with the O-rings into plug
M16x1,5
with engine oil and place it in the oil filter container.
.
M6
10 Nm (7.4 lbf ft)
M12x1,5
20 Nm
(14.8 lbf ft)
and using a long hexagon socket
M20x1,5
15 Nm
(11.1 lbf ft)
and tighten.
10 Nm
lubricated with
(7.4 lbf ft)
engine oil
143
with the oil