10/REAR WHEEL
Adjusting the toe width of rear axle
14.7
Warning
Danger of accidents Changes to the chassis can strongly influence how the vehicle handles.
–
After making changes, always ride slowly to allow yourself to respond to vehicle handling.
2
2
0 0 1
1
3
0 0 3
0 0
–
Loosen the screws
Alternative 1
–
Insert the tool
element.
Alternative 2
–
Use a special tool on the rear wheel eccentric.
Hook wrench (83019011000) (
–
To adjust the chain tension
to rotate the rear wheel eccentric element forward or backward.
Specification
Chain tension
Info
Rotating the rear wheel eccentric element forward increases chain tension.
Rotating the rear wheel eccentric element backward reduces chain tension.
The rear wheel eccentric element should always be positioned such that the
grease nipple
ground clearance.
100094-10
–
Fully tighten screws
Specification
Screw, rear wheel eccentric element
–
Remove tool
–
Engage 1st gear.
–
Loosen nuts
–
Jack up the vehicle. (
–
Remove the nuts
–
Check parts for damage and wear. Replace damaged or worn parts.
Info
The left and right toe width should have the same settings.
100102-10
Setting a narrow toe width:
–
Mount the wheel hub
–
Mount the conical ring
–
Mount the spacing sleeve
–
Mount the washer and the new self-locking nut.
100103-10
by four turns.
from the tool set into the hole
P. 210)
, use the special tool to slowly turn at the rear wheel
is visible. This ensures that the vehicle has the greatest
.
.
of the wheel hubs on both sides.
P. 14)
on both sides and take all parts off of the rear axle.
.
with the cone facing outward.
with the cone facing inward.
of the rear wheel eccentric
140... 145 mm (5.51... 5.71 in)
M8
20 Nm
(14.8 lbf ft)
63