A-Arm Bottom - Changing The Bearing - KTM 450 XC 2008 Repair Manual

61/ATV FRONT SECTION

A-Arm bottom - changing the bearing

27.10
Info
The operations are the same on the left and right sides.
–
Remove the A-arms. ( P. 178)
–
Mount lock ring
Circlip pliers reverse (51012011000)
Info
When mounting the lock ring, do not damage the rubber boot.
600467-10
–
Loosen nuts
600470-10
–
Screw the nuts on the new heim joints. Mount the heim joints
600471-10
–
Insert the tool
Camber gauge (83019014000) (
–
Align marking
Info
Nuts
–
Install the A-arms. (
600472-10
.

. Remove heim joint . Screw the nuts off of the heim joints.
 
in the heim joint and clip onto the A-arm.

P. 211)
with the upper edge of the A-arm by rotating the heim joint.

are tightened when the A-arm is installed.

P. 178)
180
.
