04/SHOCK ABSORBER, SWINGARM
Rear shock absorber - disassembling the shock absorber
8.23
Alternative 1
–
Measure the overall spring length when not under tension.
Info
The spring preload
when it is unloaded and when it is installed.
–
Tighten the spring by turning the adjusting ring to the specified measurement.
Specification
Spring preload
Standard
Hook wrench (83019002000)
Alternative 2
–
Tighten the spring by turning the adjusting ring to the measurement determined
upon removal.
Hook wrench (83019002000)
400363-11
–
Tighten lock nut
Info
Adjusting ring
ring too tightly to avoid damaging the thread.
If you increase the spring preload, you should also slightly increase the
rebound damping.
–
Install the rear shock absorber. (
200232-11
–
Remove the spring of the rear shock absorber. (
–
Note down the current state of the rebound and compression damping.
–
Fully open the adjusting elements of the rebound and compression damping.
–
Remove lock ring
–
Remove protecting sleeve
200234-10
–
Remove screw
200235-10
is the difference in length between the spring
and adjusting ring
.
is made of plastic. Therefore, do not lock the adjusting
P. 37)
.
.
of the reservoir.
3 mm (0.12 in)
P. 37)
38