30/ASSEMBLING THE ENGINE
Installing the primary gear with the free-wheel-gear
20.23
Installing the oil pumps
20.24
–
Ensure that spring washer
600357-10
–
Oil the free-wheel in the primary gear.
–
Slide the primary gear with the free-wheel onto free-wheel-gear
both on the crankshaft.
Info
The free-wheel-gear must rotate counterclockwise when it is mounted.
–
Mount and tighten nut
Specification
600358-10
Nut, primary gear
–
Mount external rotor
The marking should not be visible after installation.
–
Fill the oil pump with engine oil.
600359-10
–
Insert pin
–
Insert the oil pump shaft into the engine case. Ensure that the pin engages in the
internal rotor.
600360-10
–
Position oil pump cover
Specification
Screw, oil pump cover
–
Insert the long pin
600361-10
is seated properly.
.
M20LHx1,5
and internal rotor
in the second drill hole
of the oil pump shaft
. Mount and tighten screws
M5
into the oil pump shaft.
and mount them
150 Nm
Loctite
®
243™
(110.6 lbf ft)
with marking
facing inward.
.
.
Loctite
®
222
6 Nm
(4.4 lbf ft)
137